How to use the GumstixIII_EM?

Aug 18, 2008 at 5:38 PM
I don't have a gumstix at home. I wanna do a simulation test using the VS2005.
I built the GumstixIII_EM_1 and it was succeeded.
How to set the target device connectivty options? 
I failed after i attched the GumstixIII_EM SDK V1.0 Emulator device. The output results:

(CoreCon) Error: A service has failed to connect. Make sure that all services are correctly configured, and that the targeted device is not already in use.
PB Debugger The Kernel Debugger is waiting to connect with target.
(Corecon) Unable to change device selection at this time.  Make sure that you are not already connected to a device before trying again.
PB Debugger The Kernel Debugger has been disconnected successfully.
(CoreCon) Failed to connect debug message service! Please check the transport settings.
(CoreCon) Transport service failed to connect
(CoreCon) Error: A service has failed to connect. Make sure that all services are correctly configured, and that the targeted device is not already in use.

Aug 18, 2008 at 10:18 PM
Read the platform builder documentation (online on MSDN). There is a step by step procedure which discribes what you are trying to do.